AG538A CAR WINDSHIELD REPAIR KIT

Offer's description

Car glass damage repair kit. Get rid of unsightly spider veins from the glass and protect the chips from spreading further. Product Features:Brand new, high quality product. With this kit, you can repair the windshield of your car yourself. You can easily and quickly get rid of chips caused most often by stone impacts from under the wheels of other cars. Chips and deep scratches caused by cracks will become almost invisible, and the glass will be protected against further damage growth. It is suitable for repairing damage to glass panes in the shape of small meshes and longitudinal cracks no longer than 15 cm. Thanks to the large amount of glue in the set, the set is suitable for reusability. It pays for itself on the first use, the cost of repairing them is many times lower than in authorized car service centers. Quick effect - the whole procedure of applying the glue takes a few minutes, and the glue itself dries within 10 minutes of exposing it to sunlight (UV glue). USER MANUAL EN:Before commencing work, clean and degrease the glass on both sides. Any glass residue in the form of chips and small crumbs should also be removed. Place the screw applicator (plunger) over the crack so that the end of the applicator is in contact with the center of the crack a little tighter, then unscrew the plunger from the applicator. Put the correct amount of glue in the applicator (depending on the size of the crack). Usually, 5-10 drops are enough for smaller damage (4-7 mm in diameter). Screw the plunger into the applicator as far as it will go, then unscrew and screw the plunger back in again (preferably several times) so that the glue can get into as many nooks and crannies as possible, pushing the air out of the damage at the same time. By screwing in the plunger, observe if the glue spreads in the damage, filling it completely. If necessary, add another portion of glue. The glue should completely fill the damage. Remove the plunger from the applicator. Wait for the vacuum to suck the air from under the applicator. Screw the plunger back in as far as it will go. Make sure the damage is completely filled. Remove the plunger and applicator. Apply 2 drops of glue to the sealed damage and cover it with protective foil, ironing it gently so that no air bubbles are left underneath. Expose to the sun for 10 minutes or expose with a UV lamp. The adhesive curing process takes place only under the influence of radiation UV.Do use a razor blade to scrape off excess glue (with quick, gentle movements at an angle of 90°, without worrying about scratching the glass). In the case of a longer longitudinal crack, apply the adhesive along the crack (without the use of an applicator) and then cover the entire length of the crack with a protective foil. Then follow the previous instructions. If there are any shortcomings in the bonding, the procedure should be repeated. Included:Filling resin 2.5 mlResin (glue) applicatorRazor bladeCleaning cloth3x o-ring3x silicone sealant5x curing filmSyringWe invite you to place an order!