4x Pattex Fix Decor Mounting Adhesive 380g

4x Pattex Fix Decor Mounting Adhesive 380g - description

Set 4x Pattex Fix Decor 380g is a professional installation adhesive for interiors. It permanently glues a wide range of materials such as: wood, gypsum, polystyrene, ceramics, chipboard, gypsum and cork. Replaces screws, nails, dowels or other adhesives when installing wall and plinth mouldings, panels, cornices, decorative boards, decorative profiles, wooden mouldings, door signs, etc. It is characterized by water resistance and flexibility.

Product advantages:IndoorSuitable for absorbent materialsSolvent-free – eco-friendlyEasy to use and cleanWaterproof and flexibleCan be paintedFills cavities in the substrate

Possible applications:WoodGypsumPolystyreneCeramicsParticleboardGypsum boardCorkComplementing the line of basic assembly adhesives Pattex Fix Wood and Fix Metal.

GLUING METHOD:1. Thoroughly clean the surfaces to be bonded from dust, grease, oil, residual water and other substances that reduce the adhesion of the adhesive. If the adhesive is applied below 0°C, make sure that there is no frost or snow on the glued surfaces. If the ground has unevenness, it should be leveled. The substrate must be stable. If necessary, protect the adjacent surfaces with paper tape before application.2. Cut off the end of the cartridge just above the thread. The dispensing tip should be cut at an angle. Place the cartridge in a special gun.3. Apply the adhesive in lines or spots to the substrate or the material to be glued. Do not apply the adhesive directly to the edges. For wide surfaces, the adhesive should be applied "wavy" to increase initial adhesion. When using the adhesive indoors, ensure adequate ventilation. For outdoor use or use in rooms with high humidity, the vertical line marking technique should be used. Also, when gluing two non-absorbent surfaces, the technique of vertical line application should be used to facilitate the evaporation of the solvent.4. Join the bonded surfaces and immediately disconnect to evaporate the solvent, wait (3-5 min for absorbent surfaces, 5-8 min for non-absorbent surfaces) and join again with strong and even pressure.5. Fresh dirt should be cleaned immediately after application with a dry cloth and then with acetone or white spirit. The hardened material can only be removed mechanically.6. If the material is applied incorrectly, do not peel off, but correct by moving. In the case of gluing on vertical surfaces, support the materials to be glued for min. 24 hours.

---

Payment options

• Bank transfer

---

Delivery options

• Collection in person
• National delivery
• International delivery

---

Shipping to countries